N1200 Stock U-Boot Variables

From Thecus Wiki

U-Boot 1.1.3 (FSL Development) (Feb 6 2007 - 12:26:26) MPC83XX

Clock configuration:
  Coherent System Bus:  266 MHz
  Core:                 266 MHz
  Local Bus Controller: 266 MHz
  Local Bus:             33 MHz
  DDR:                  266 MHz
  I2C:                  266 MHz
  TSEC1:                266 MHz
  TSEC2:                266 MHz
  USB MPH:               88 MHz
  USB DR:                88 MHz
CPU: MPC83xx, Rev: 11 at 266.666 MHz
Board: Thecus N1200
I2C:   ready
DRAM:  SDRAM on Local Bus is NOT available!
   DDR RAM: 128 MB
FLASH:  8 MB
PCI1 32bit on PMC1 & PMC2 & PMC3
In:    serial
Out:   serial
Err:   serial
Net:   Freescale TSEC0: PHY is Realtek RTL8211B (1cc912)
Freescale TSEC1: PHY id 1410c87 is not supported!
Freescale TSEC1: No PHY found
Freescale TSEC0, Freescale TSEC1
Thecus Version: 4, PIC version: 4

bootcmd=run flashboot
ramboot=setenv bootargs root=/dev/ram init=/linuxrc rw console=$consoledev,$baudrate $othbootargs;echo wait 5 seconds;sleep 5;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;bootm $loadaddr $ramdiskaddr
flashboot=setenv bootargs root=/dev/ram init=/linuxrc rw console=$consoledev,$baudrate $othbootargs;bootm FE180000 FE320000
flashing=echo wait 3 seconds;sleep 3;tftp 100000 flashing1200.img;autoscr 100000
bootdelay=1
baudrate=115200
loads_echo=1
ipaddr=172.16.88.12
serverip=172.16.88.222
gatewayip=172.16.88.222
netmask=255.255.255.0
bootfile=uImage
loadaddr=200000
netdev=eth0
consoledev=ttyS0
ramdiskaddr=F00000
ramdiskfile=uramdisk
othbootargs=ramdisk_size=32768
ethact=Freescale TSEC0
version=4
ethaddr=00:12:34:56:78:90
eth1addr=00:12:34:56:78:91
stdin=serial
stdout=serial
stderr=serial